AFL OFL280 FlexTester - Event Threshold Settings; FTTx - In Service Mode

16
Event Threshold Settings
Event threshold settings may be modied in FTTx - In Service, FTTx - PON Construction, Full Auto, and
Expert test modes.
Event Thresholds: FTTx – In Service mode
In the FTTx - In Service test mode the [Event] parameter is set to [Auto] by default.
1. From the FTTx - In Service test mode page, display the Event menu
A
using keys .
2. Use keys to highlight the desired setup parameter.
3. Use keys to set/change the highlighted parameter.
Note: Event Loss and Reectance threshold settings are used to determine whether or not a detected
anomaly should be reported as an event and included in the event table, and if so how it should be
classied by event type (e.g. as a reective or non-reective event).
Types of events are described in section titled “Event Types”.
This parameter may be set to:
[Default] - OFL280 sets [Event Loss]
and [Event Reectance].
[User] - [Event Loss] and [Event
Reectance] are set by the user. Allows
the user to perform FTTx PON tests
using manual settings.
A