AGFA CR 85-X Reference Manual

34
4451C EN 2013-04-30Introducing the CR 85-X
CR 85-X DIGITIZER
Switching off the CR 85-X
Before switching off
Check that the CR 85-X is not scanning an image plate. If the CR 85-X is
scanning an image plate, the status indicator at the top of the machine is
green and flashing.
Switching off
It is recommended to switch off the CR 85-X at the end of the day.
Place the main switch in position ‘OFF’.
WARNING: Only switch off the CR 85-X if you do not intend to digitize
emergency image plates overnight. Switching on the CR 85-X takes a
few minutes. During this time emergency digitizing is not possible!
Note: To remove the device from the mains supply disconnect the mains plug.

AGFA CR 85-X Specifications

General

Brand	AGFA
Model	CR 85-X
Category	Measuring Instruments
Language	English