AGFA CR 85-X Reference Manual

64
4451C EN 2013-04-30Advanced operation (‘Key-operator mode’)
CR 85-X DIGITIZER
Installing a new software version
Via this key-operator function you can copy a new software version from a
floppy disk to the hard disk of the CR 85-X and activate the new software.
To install a new software version:
1 Check that the CR 85-X is not scanning an image plate.
If the CR 85-X is scanning an image plate, the status indicator at the top of the
machine is green and flashing.
2 In the key-operator main menu, select ‘Install’ via the Up and Down keys and
confirm.
The CR 85-X will display the Install menu:
3 In the Install menu, select ‘Software’ via the Up and Down keys and confirm.
Note: When an error occurs during installation, refer to Chapter 4,
‘Troubleshooting’.
Note: Newer versions of the digitizer have a USB port instead of a floppy disk
drive. This manual describes how to use a floppy disk. The usage of a USB
flash drive is analogous.
Queue management
Digitizer set-up
Date and Time
Send test image
System info
Install
Save configuration
Fast preview
: quit
: ok
: select
KEY-OPERATOR
MENU
SERVICE XXXXX
Software
Language
Configuration
: quit
: ok
: select
INSTALL
SERVICE XXXXX

AGFA CR 85-X Specifications

General

Brand	AGFA
Model	CR 85-X
Category	Measuring Instruments
Language	English