AGFA CR 85-X Reference Manual

54
4451C EN 2013-04-30Advanced operation (‘Key-operator mode’)
CR 85-X DIGITIZER
Changing the destination
If an image processing station is out of operation, you can reroute the images
to another image processing station. Start as in ‘Enabling/disabling image
transmission’ on page 52:
1 In the key-operator main menu, select ‘Digitizer set-up’ via the Up and Down keys
and confirm.
The CR 85-X will display the Digitizer set-up menu:
2 Select the Source rerouting field via the Up and Down keys.
3 Select the image processing station from which you want to redirect the images via
the Left and Right keys.
4 Select the Target rerouting field via the Up and Down keys.
Note: If you do not press a key within 1 minute, the CR 85-X will exit the key-
operator mode.
Note: You can only redirect the images of one image processing station.
Queue management
Digitizer set-up
Date and Time
Send test image
System info
Install
Save configuration
Fast preview
: quit
: ok
: select
KEY-OPERATOR
MENU
SERVICE XXXXX
Process.station: enabled
Reroute process.station
[PPname1]
to
[PPname2]
Scan mode: standard
Acoustic signal: enabled
: quit
: ok
: select
: change
DIGITIZER
SET-UP
SERVICE XXXXX
Target rerouting
field
Source rerouting
field

AGFA CR 85-X Specifications

General

Brand	AGFA
Model	CR 85-X
Category	Measuring Instruments
Language	English