Operation 2
3200P pH Meter User Guide 27
During a measurement in this mode, you can view
measuring parameters, calibrate the electrode, and so
forth. After measurement ends, you can save and output
the results.
Press [Cancel] to exit this mode or press [Measure] to
begin the next measurement.
To manually set the solution temperature
If using an ATC probe (an ATC probe is connected to the
meter), the meter uses the temperature data from the probe.
Otherwise, the user must enter the temperature value of the
sample solution.
1 Press [Setup] and select Set Manual Temp.
2 Enter the temperature in the dialog.
Figure 12 Entering temperature
To Next Page
Loading...
