Operation 2
3200P pH Meter User Guide 23
Accessing setup parameters
From the initial state display, press [Setup] to display a
menu with choices to define system parameters (date, time,
temperature, and so forth) or select the measuring mode.
Choices include: Measuring Mode, System Setup, Language select,
Set Manual Temp, and Set Condition. See Figure 10.
To make a selection, use the arrow keys to highlight the
desired parameter, then press [Enter] to view its settings.
Press [Cancel] to exit.
[Measuring Mode]
Select to set the measuring mode used when taking
measurements: Continuous Mode, Timed Reading (Timed
Reading Mode), Auto- Lock Mode (Auto- Lock Reading Mode).
See “To select a measuring mode” on page 25.
[Set Manual Temp]
Select to manually enter the current sample solution
temperature. If the meter is not connected with an ATC
probe, the temperature value must be input manually.
Otherwise, the meter uses the ATC probe value. See “To
manually set the solution temperature” on page 27.
Figure 10 The setup menu
To Next Page
Loading...
Need help?
General
