Operation 2
3200P pH Meter User Guide 25
To select a measuring mode
The meter supports three measuring modes: Continuous Mode,
Timed Reading, and Auto-Lock Mode. After selecting a parameter
and measuring mode, the next measurement will use the
new settings.
To select a measuring mode:
1 Press [Setup] and then [Enter]. The meter displays is
similar to Figure 11. The left side displays parameters.
The right side lists the measuring modes. A
√ next to a
mode means that this mode has been selected in the
current setup.
2 Use the arrow keys to highlight the desired mode.
3 Press [Setup] to select the highlighted mode.
4 Press [Enter] to save the new setup, exit the Setup mode,
and return to the initial state.
Press [Cancel] to exit the Setup mode without saving changes.
Figure 11 Measuring mode
To Next Page
Loading...
