Menu Example 2 The following example shows how to use the recall menu feature as a
shortcut to set the
POWER ON command back to its original setting.
You must perform the steps in Example 1 before you start this example.
1 Use recall menu to return to the
POWER ON command.
This returns you to the
POWER ON command, which was the last
command used before you exited the menu in the Example 1.
2: POWER ON
2 Move down to the “
PARAMETER” choices.
The first parameter choice is “
LAST STATE” (the current setting from
Example 1).
LAST STATE
3
Move across to the
“DEFAULT” choice.
1
Set the parameter back to its original value.
DEFAULT
4 Save the change and turn off the menu.
The function generator beeps and displays a message to show that the
change is now in effect. You are then exited from the menu.
ENTERED
Recall Menu
Shift
>
¿
Enter
<
1
You can also use the knob to scroll left or right through the choices on each
level of the menu.
2
Chapter 2 Front-Panel Menu Operation
A front-panel menu tutorial
37
To Next Page
Loading...
Need help?
General
