To Turn Off the Comma Separator
The multimeter can display readings on the front panel with or without
a comma separator. The following steps show how to disable the comma.
08.241,53 VDC
1 Turn on the menu.
A: MEAS MENU
2 Move across to the
SYS MENU choice on the “menus” level.
D: SYS MENU
3 Move down a level and then across to the
COMMA command.
7: COMMA
4 Move down a level and then move across to the “OFF” choice.
OFF
5 Save the change and turn off the menu.
The comma separator setting is stored in non-volatile memory, and
does not change when power has been off or after a remote interface reset.
∨
<
>
>
<
>
08.24153 VDC
With comma separator
(factory setting) Without comma separator
∨
>
Shift <
On/Off
Auto/Man
ENTER
2
Chapter 2 Front-Panel Menu Operation
To Turn Off the Comma Separator
37
To Next Page
Loading...
