6 Move down a level and then across to the “ON” choice.
ON
7 Save the change and exit the menu.
Notice that the
Mem (memory) annunciator turns on to indicate that the
multimeter is ready to store readings. Up to 512 readings can be stored
in first-in-first-out (
FIFO) order. When memory is full, the Mem annunciator
will turn off.
Readings are preserved until you re-enable reading memory at another
time, turn off the power, or perform a remote interface reset.
8 Trigger the multimeter three times.
This stores three readings in memory.
9 Use menu recall to retrieve the stored readings.
This takes you to the “
SAVED RDGS” command in the SYS MENU.
2: SAVED RDGS
> ∨
Single
Single
Single
Auto/Man
ENTER
Shift >
Recall
2
Chapter 2 Front-Panel Menu Operation
To Use Reading Memory
47
To Next Page
Loading...
