Part # N7210 – 90006 NT 4.0 to Microsoft Windows XP Professional with Service Pack 2 Upgrade Procedure
Page 34 of 34
Printed in USA
5. Copy the files in the directories from either the CD or the Network location and
paste them to the corresponding file on the hard drive. Select Yes to All to update
the existing files.
6. Repeat until all of the directories have been copied.
7. Close Windows Explorer.
System Startup
System Restart for the 2.8 Ghz Controller
1. Reboot the machine. Logon as Administrator.
2. You’ll see an Itex window pop up, press any key to continue. Logon name = “s”.
Select “Startup” and press <ENTER>. Select “Automatic Startup” and press
<ENTER>. Progress through errors.
3. The first time the system is booted up you will receive error messages about the
Galil drive. Press OK several times to close the error windows. Press any key if
necessary to close other error messages. At Full Machine Reset, select “y”.
Note: If error messages continue to occur during startup – shut the system down and repeat steps 1 – 3. If this problem
continues, you may need to repeat the Restore System Specific Files steps.
4. Once the system is started up, restore NDF and RTF files to the machine panel
applications.
This information is subject to change without notice
© Agilent Technologies, Inc. 2005
February 23, 2005
To Previous Page
Loading...
Need help?
General
