Maintenance 3
Maintenance 43
3
Remove any sample loop adapters from the sample loop
block and cover.
a Grip the sample loop adapter using needle nose pliers
in the locations shown in Figure 30.
b Squeeze the needle nose pliers together and gently pull
the sample loop adapter from the block or cover as
shown in Figure 30.
Figure 30 Removing a sample loop adapter (G4556-20178 shown) from
the loop cover (loop cover shown, the valve/loop cover is
similar)
c Repeat as necessary until all sample loop adapters
have been removed from both the sample loop block
and cover.
Sample Loop Cover
Sample Loop Adapter
To Next Page
Loading...
