1b-19
Operation Reference
Function
—With TERMINATOR set to ON, the asynchronous state signal is output in the frame where the
next message was supposed to occur (as determined by the collapse cycle).
•CONT Mode Example
Start Cycle: 10
Start Frame: 127
Collapse Cycle: 1 (2
1
) and 2 (2
2
)
Stop: Selected in frame f+ 1
—Since HEADER is set to ON, the idle signal is output at Frame 126.
—With TERMINATOR set to ON, and IMMEDIATE STOP set to OFF, selecting stop will replace
the next message with the asynchronous signal.
SSID/NID Roaming Example When the roaming function with SSID and NID is set to on with
the following conditions, the contents in each phase are shown in the following table:
• 6400 bps, 4-level FSK
• Call in Phase: A
• Address Type: Long Address
Cycle1010 1111 1111 1111 1111 ...11
Frame 126 127 0 1 2 3 4 5 6 7 ... 11
CC = 1 idle message idle message idle message idle asyn-
chronous
CC = 2 idle message idle idle idle message idle idle idle message ... asyn-
chronous
Cycle1010111111...c cc cc
Frame 126 127 0 1 2 .... f f + 1 f + 2 f + 3 f + 4
CC = 1 idle message idle message idle ... message idle asyn-
chronous
CC = 2 idle message idle idle idle ... message idle idle idle asyn-
chronous
To Next Page
Loading...
Need help?
General
