1 Installing the GC
Installation and First Startup 25
Step 5 View the System Setup Wizard
The system setup wizard walks through the most important steps needed to install and
configure the GC. It provides a way to enter only the critical settings needed to get started
quickly, leaving all other configuration settings at their default values. These steps include:
• Unpacking
• Setting the system date, time, and IP address
• Setting the gas units, gas types, and similar choices
• Connecting gases and checking for leaks
• Installing a sampler, if available
• Running a checkout sample
You can follow the system setup wizard, or cancel it and follow the procedures here instead.
Whether using the wizard or not, this guide provides all of the supporting information needed
for installation.
After exiting the system setup wizard, you can re-launch it at any time. On the GC touchscreen,
navigate to Settings > System Setup and touch Run System Setup.
To Next Page
Loading...
