A Making Swagelok Connections
Installation and First Startup 67
Using a Swagelok Tee
To supply gas from a single source to more than one input, use a Swagelok Tee.
Do not combine valve actuator air with flame ionization air. The valve action will cause major
upsets in the detector signal.
Materials needed:
• 1/8-inch preconditioned copper tubing
• Tubing cutter
• 1/8-inch Swagelok nuts and front and back ferrules
• 1/8-inch Swagelok Tee
• Two 7/16-inch wrenches
• 1/8-inch Swagelok cap (optional)
1 Cut the tubing where you want to install the Tee. Connect the tubing and Tee with a
Swagelok fitting. See Figure 21.
Figure 21. Swagelok tee
2 Measure the distance from the Tee to the instrument fittings. Attach copper tubing to the
open Tee ends with Swagelok fittings.
Cap
Tee fitting
Nut and
ferrules
To Next Page
Loading...
Need help?
General
