Laser Safety Information Getting Started
Agilent 8163A/B, 8164A/B & 8166A/B Mainframes, Sixth Edition 35
Laser class 1M label
A sheet of laser safety labels is included with the laser module as required.
In order to meet the requirements of IEC 60825-1 we recommend that you
stick the laser safety labels, in your language, onto a suitable location on
the outside of the instrument where they are clearly visible to anyone
using the instrument
Figure 2 Class 1M Safety Label - Agilent 81655A/6A/7A, 81662A/3A, 81600B family, (81480B/82B/ 81640B/42B/80B/82B/72B),
81980A/40A/89A/49A, (81649A/89A/89B).
Please pay attention to the following laser safety warnings:
• Under no circumstances look into the end of an optical cable attached to the op-
tical output when the device is operational. The laser radiation can seriously
damage your eyesight.
• Do not enable the laser when there is no fiber attached to the optical output
connector.
• The laser is enabled by pressing the gray button close to the optical output con-
nector on the front panel of the module. The laser is on when the green LED on
the front panel of the instrument is lit.
• The use of other optical instruments with this product will increase the hazard
to your eyes.
• The laser module has built-in safety circuitry which will disable the optical out-
put in the case of a fault condition.
• Refer servicing only to qualified and authorized personnel.
WARNING
To Next Page
Loading...
Need help?
General
