Chapter 4 Remote Interface Reference
Status Reporting Commands
103
4
*SRE <enable value>
This command enables bits in the Status Byte enable register.
*SRE?
This command queries the Status Byte Enable register. The power supply returns a
decimal value which corresponds to the binary-weighted sum of all bits set in the
register.
*STB?
This command queries the Status Byte summary register. The *STB? command is
similar to a serial poll but it is processed like any other instrument command. The
*STB? command returns the same result as a serial poll but the “Request Service”
bit (bit 6) is not cleared if a serial poll has occurred.
*WAI
This command instructs the power supply to wait for all pending operations to
complete before executing any additional commands over the interface. Used only
in the triggered mode.
To Next Page
Loading...
Need help?
General
