Chapter 2 Initial Operation
Preliminary Checkout
29
2
Preliminary Checkout
The following steps help you verify that the power supply is ready for use.
1 Verify the power-line voltage setting on the rear panel.
The power-line voltage is set to the proper value for your country when the power
supply is shipped from the factory. Change the voltage setting if it is not correct. The
settings are: 100, 115, or 230 Vac.
2 Verify that the correct power-line fuse is installed.
The correct fuse is installed for your country when the power supply is shipped from
the factory. For 100 or 115 Vac operation, you must use a 2.5 AT fuse. For 230 Vac
operation, you must use a 2.0 AT fuse.
3 Connect the power-line cord and turn on your power supply.
The front-panel display will light up and a power-on self-test occurs automatically
when you turn on the power supply.
See “Power-Line Voltage Selection”, starting on page 24 in chapter 1 if you need to
change the power-line voltage or the power-line fuse.
To replace the 2.5 AT fuse, order Agilent part number 2110-0913.
To replace the 2 AT fuse, order Agilent part number 2110-0982.
To Next Page
Loading...
Need help?
General
