Chapter 3 Front-Panel Operation
Remote Interface Configuration
54
5 Save the change and turn off the I/O configuration mode.
The RS-232 baud rate and parity selections are stored in non-volatile memory, and
does not change when power has been off or after a remote interface reset. The power
supply displays a message to show that the change is now in effect. If the baud rate
and the parity are not changed, “NO CHANGE” will be displayed for one second.
Note To cancel the I/O configuration mode without any changes during the baud rate and
parity selection, press the “I/O Config” key until the “NO CHANGE” message is
displayed.
CHANGE SAVED
I/O Config
To Next Page
Loading...
Need help?
General
