50 G1369C LAN Interface User Manual
2Getting Started
PC and Agilent ChemStation Setup
Agilent ChemStation Setup
1 Start the Configuration Editor of the Agilent ChemStation.
Figure 41 Changing the TCP/IP settings of the Agilent ChemStation
2 Add a TCP/IP connection to communicate with the LAN Interface Card.
Use the IP address of the LAN Interface Card.
3 Save the configuration, close the Configuration Editor and start the
Agilent ChemStation.
If using a corporate LAN, IP addresses need to be supplied by the responsible IT
department. Also the LAN needs to be able to handle additional traffic.
To Next Page
Loading...