G1369C LAN Interface User Manual 39
Getting Started 2
Manual Configuration
With Telnet
Whenever a TCP/IP connection to the card is possible (TCP/IP parameters
set by any method), the parameters may be altered by opening a Telnet
session.
1 Open the system (DOS) prompt window by clicking on Windows START
button and select “Run...”. Type “cmd” and press OK.
2 Type the following at the system (DOS) prompt:
c:\>telnet <IP address>
Figure 26 Telnet - Starting a session
where <IP address> may be the assigned address from a Bootp cycle, a
configuration session with the Agilent Instant Pilot (G4208A) or
Handheld Controller (G1323A/B), or the default IP address (see
“Configuration Switches” on page 21).
When the connection was established successfully, the card responds
with the following:
Figure 27 A connection to the module is made
3 To change a parameter follows the style:
parameter value
for example: ip 134.40.24.230
To Next Page
Loading...