40 G1369C LAN Interface User Manual
2Getting Started
Manual Configuration
then press [Enter], where parameter refers to the configuration
parameter you are defining, and value refers to the definitions you are
assigning to that parameter. Each parameter entry is followed by a
carriage return.
Table 8 Telnet Commands
Value Description
? displays syntax and descriptions of commands
/ displays current settings
ip <x.x.x.x> sets new ip address
sn <x.x.x.x> set new subnet mask
gw <x.x.x.x> sets new default gateway
quit saves changes and exit shell
exit exits shell without saving changes
Any time during the Telnet session you can type “?” then press [Enter] to view available
configuration parameters, the correct command format, and a list of additional commands
to display.
To Next Page
Loading...
Need help?
General