To Next Page

To Previous Page

Agilent InfinityLab LC Series 1260 Infinity II Isocratic- and Quaternary Pumps User Manual 103

Error Information

General Error Messages

Leak Sensor Open

Error ID: 0083

The leak sensor in the module has failed (open circuit).

The current through the leak sensor is dependent on temperature. A leak is

detected when solvent cools the leak sensor, causing the leak-sensor current to

change within defined limits. If the current falls outside the lower limit, the

error message is generated.

Leak Sensor Short

Error ID: 0082

The leak sensor in the module has failed (short circuit).

The current through the leak sensor is dependent on temperature. A leak is

detected when solvent cools the leak sensor, causing the leak sensor current to

change within defined limits. If the current increases above the upper limit,

the error message is generated.

Probable cause Suggested actions

Leak sensor not connected to the Power

Switch board.