Instructions for Use
MS120 Single Stage Rotary Vane Pumps User Manual / 87-900-150-01(B) 163/198
Lubricants
In the following table are reported the oil recommended for generic
use.
Tab. 7 Lubricants
Ambient temperature Viscosity Agilent Technologies oil
12 – 35 °C ISO 53 DS45
In case of change of the type of lubricant, it is necessary to proceed
with a pump by letting it run at maximum vacuum for at least 5
minutes.
For this operation use a quantity of oil such as to reach the minimum
level indicated on the tank.
Discharge again the oil and proceed with new oil charge.
Decommissioning
Drain the oil from the pump prior to the removal. If the oil is
polluted, flush the pump with fresh oil (see “Oil change”).
Drain the oil from the tank, plug the inlet and the discharge ports and
store the pump without oil.
Return for repair
NOTE
Before returning the pump to the constructor for repairs the "Health and Safety
Certification" sheet attached to this instruction manual must be filled-in and
sent to the local sales office. A copy of the sheet must be inserted in the pump
package before shipping.
If a pump is to be scrapped, it must be disposed of in accordance
with the specific national standards.
To Next Page
Loading...
Need help?
General
