Instructions for Use
180 MS40-S User Manual
Transport & Storage
The pumps are shipped to the customer inside cardboard boxes.
Total weight of the pack, including the pump, is about 35 kg.
The case must be handled with care, using appropriate lifting equipment.
When moving the case, ensure that it is securely bound to the lifting equipment
and that the equipment is strong enough to support the weight.
The pump’s working environment is a traditional industrial environment. Naturally
sites with corrosive vapors or excessive heat are best avoided.
Room temperature should ideally be between 12 °C and 40 °C. If the temperature is
not inside this range, consult Agilent technical service for the changes required.
When transporting and storing the pumps, the following environmental
requirements should not be exceeded:
temperature: from -20° to +70 °C
relative humidity: 0 ÷ 95 % (non-condensing)
Product description
This equipment is destined for use by professionals. The user should read this
instruction manual and any other additional information supplied by Agilent before
operating the equipment. Agilent will not be held responsible for any events
occurring due to non-compliance, even partial, with these instructions, improper use
by untrained persons, non-authorized interference with the equipment or any action
contrary to that provided for by specific local standards.
The MS40-S are single-stage, rotary vane pumps oil sealed, controlled by an
electronic unit.
Detailed information is supplied in the "Technical Information" section.
To Next Page
Loading...
Need help?
General
