Service Appendix D
Series N6700 User’s Guide 189
Command Errors (continued)
−160 Block data error
Generic block data error
−161 Invalid block data
The number of data bytes sent does not match the number of bytes specified in the header.
−168 Block data not allowed
Data was sent in arbitrary block format but is not allowed for this command.
−170 Expression error
Generic expression error
−171 Invalid expression data
The expression data element was invalid.
−178 Expression data not allowed
Expression data element was sent but is not allowed for this command.
Execution Errors (these errors set Standard Event Status register bit #4)
−200 Execution error
Generic syntax error
−220 Parameter error
A data element related error occurred.
−221 Settings conflict
A data element could not be executed because of the present instrument state.
−222 Data out of range
A data element could not be executed because the value was outside the valid range.
−223 Too much data
A data element was received that contains more data than the instrument can handle.
−224 Illegal parameter value
An exact value was expected but not received.
−225 Out of memory
The device has insufficient memory to perform the requested operation.
−226 Lists not same length
One or more lists are not the same length.
−230 Data corrupt or stale
Possible invalid data. A new reading was started but not completed.
−231 Data questionable
The measurement accuracy is suspect.
−232 Invalid format
The data format or structure is inappropriate.
−233 Invalid version
The version of the data format is incorrect to the instrument.
−240 Hardware error
The command could not be executed because of a hardware problem with the instrument.
−241 Hardware missing
The command could not be executed because of missing hardware, such as an option.
−260 Expression error
An expression program data element related error occurred.
−261 Math error in expression
An expression program data element could not be executed due to a math error.
To Next Page
Loading...
Need help?
General
