Appendix D Service
188 Series N6700 User’s Guide
Command Errors (continued)
−108 Parameter not allowed
More parameters were received than were expected.
−109 Missing parameter
Fewer parameters were received than were expected.
−110 Command header error
An error was detected in the header.
−111 Header separator error
A character that was not a valid header separator was found in the command string.
−112 Program mnemonic too long
The header contains more than 12 characters.
−113 Undefined header
A command was received that was not valid for this instrument.
−114 Header suffix out of range
The value of the numeric suffix is not valid.
−120 Numeric data error
Generic numeric data error.
−121 Invalid character in number
An invalid character for the data type was found in the command string.
−123 Exponent too large
The magnitude of the exponent was larger than 32000.
−124 Too many digits
The mantissa of a numeric parameter contained more than 255 digits, excluding leading zeros.
−128 Numeric data not allowed
A numeric parameter was received but a character string was expected.
−130 Suffix error
Generic suffix error
−131 Invalid suffix
A suffix was incorrectly specified for a numeric parameter.
−134 Suffix too long
The suffix contains more than 12 characters.
−138 Suffix not allowed
A suffix is not supported for this command.
−140 Character data error
Generic character data error
−141 Invalid character data
Either the character data element contains an invalid character, or the element is not valid.
−144 Character data too long
The character data element contains more than 12 characters.
−148 Character data not allowed
A discrete parameter was received, but a string or numeric parameter was expected.
−150 String data error
Generic string data error
−151 Invalid string data
An invalid character string was received. Check that the string is enclosed in quotation marks.
−158 String data not allowed
A character string was received, but is not allowed for this command.
To Next Page
Loading...
Need help?
General
