Appendix E Compatibility
196 Series N6700 User’s Guide
Agilent 662xA Command Description Similar SCPI
Command
VMUX? <ch>, <input>
Generates error −113.
None
VOUT? <ch> Queries the measured output voltage of the specified output channel. The
response is a real number. The front panel display can be used to monitor
the measured output voltage (and current) of the selected output channel.
MEAS:VOLT?
VRLO <ch>
Generates error −113.
None
VRHI <ch>
Generates error −113.
None
VRSET <ch>, <x> Sets the full-scale voltage range programming for an output channel. The
power system will select the lowest operating range that will contain the
value (x). If the present operating voltage is greater than the full-scale
range selected, the present output voltage will be reduced to the full-scale
value of the new range selected. If the voltage entered is larger than the
highest possible range, an error message will result.
None
VRSET? <ch> Queries the full scale voltage range setting of an output channel. None
VSET <ch>, <voltage> Sets the voltage of the specified output channel.
VOLT
VSET? <ch> Queries the present voltage setting of the specified output channel. The
response is a real number.
VOLT?
VSTEP <ch>, <x> Increases or decreases the output channel voltage in steps. If the step
value < x > is positive, output voltage will increase by the step value, if the
step value is negative, the output voltage will decrease by the step value.
Trying to step beyond the operating range will cause a number range error.
LIST:VOLT
To Next Page
Loading...
Need help?
General
