Agilent Technologies X3500-64000

17
Technical Information
TwisTorr 304 FS On-board Controller Installation
288/304 TwisTorr 304 FS User Manual / 87-901-027-01
TwisTorr 304 FS On-board Controller Installation
The controller can be mounted in two position:
 bottom mounting (as per the complete system)
 side mounting.
To install the controller execute the following procedures.
Bottom Mounting
See the following figure.
1 Turn the pump upside-down;
2 Screw the 4 fixing studs (provided with the accessories bag) in
the holes on the bottom of pump;
3 Place the controller on the studs aligning the 4 rubber holes on
the top of the controller case;
4 Press the controller towards the pump;
5 Turn the pump again;
6 Plug the line cord and connect the pump cable to the pump;
7 Connect the mating connector with the jumper on the interlock
signal to start the pump.