102
Configuring the Station
■ Function
■ Type
■ Detection Time Range
■ API 1
■ API 2
Description Configure option input function.
Settings • No Function
• Call: Option input originates an outgoing call. Be sure to configure
“Call Origination Advanced
Settings (→page 90)” (outgoing call via option input 1 through 6).
• Answer Call / Page: Option input during an incoming call answers the call.
• Relay Latch Reset: If "Relay Output" -
“Function (→page 104)” is set to "Latch Output," the
flashing light is restored upon option input.
• API: Option input sends the CGI command configured in
“API 1 (→page 102)” “API 2
(→page 102)”.
Default values No Function
Description Set the detection method of contact input.
Settings • Make
• Break
Default values Make
Important
• Set contact input 6 for IX-DVF-2RA, IX-DVF-RA, IX-SSA-2RA, or IX-SSA-RA to "Break."
Description Set the detection confirmation time of contact input.
Settings • 0 (Immediate): Detect at input less than 200 msec.
• 200 - 2000 [msec]: Select when setting a value from 200 to 2000 msec (by 100 msec).
Enter the time in "Detection Time♦."
• 3 - 600 [sec]: Select when setting a value from 3 to 600 sec (by 1 sec).
Enter the time in "Detection Time♦."
Default values 200 msec
Description Configure the CGI command sent when “Function (→page 102)” is set to "API."
Settings URL: 1 - 128 alphanumeric characters.
Default values —
Description Configure the CGI command sent when "API" is selected in “Function (→page 102)”.
Settings URL: 1 - 128 alphanumeric characters.
Default values —
To Next Page
Loading...
Need help?
General
