Aiphone IX SERIES - Page 144

144
Configuring the Station
■ Paging
7.1.2 Tone
■ Communication Timeout Notification
■ Communication End Pretone
Description Set the receive volume when receiving a page.
Settings 1 - 10
Default values 6
Description Configure the tone heard when an outgoing call is made but the call times out without the
destination station answering.
Settings • None
• Call Pattern1
• Call Pattern2
• Call Pattern3
• Call Pattern4
• Call Pattern5
• Call Pattern6
• Tremolo Sound
• Busy Response Tone
• On Hold
• Operation Sound
• Error
• Pre Tone 1
• Pre Tone 2
• Pre Tone 3
• Communication End Pretone
• Call Queue Notification
• Waiting Reply Tone
• Select from the sound source registered in
“Custom Sound Registry (→page 85)”.
Default values Error
Description Configure the sound that plays approximately 10 seconds before the call ends.
Settings • None
• Call Pattern1
• Call Pattern2
• Call Pattern3
• Call Pattern4
• Call Pattern5
• Call Pattern6
• Tremolo Sound
• Busy Response Tone
• On Hold
• Operation Sound
• Error
• Pre Tone 1
• Pre Tone 2
• Pre Tone 3
• Communication End Pretone
• Call Queue Notification
• Waiting Reply Tone
• Select from the sound source registered in
“Custom Sound Registry (→page 85)”.
Default values Communication End Pretone