Air Techniques PROVECTA HD - 5.5 Installing the Horizontal Arm

Page 19
Air Techniques, Inc.
Equipment Setup
5.5 Installing the Horizontal Arm
Mount the horizontal arm on the installed base unit by performing the following procedure.
1. Check the spirit level and align if necessary.
1) Place the spirit level on the position, as shown in the figure.
2) Vertical leveling control.
- Loosen 6 point wrench bolt by using the wrench and insert grub screw M8x8 and
adjusted vertical level.
2. Insert the horizontal arm shaft into the base unit making sure not to pinch the 3 Wire
Harness.
3. Mount the horizontal arm brake with 2 screws,
M5x30.
4. Connect the three horizontal arm cables
A, B and C as shown below.
Top of
Base Unit
Horizontal
Arm
Horizontal
Arm Brake
Horizontal
Arm
A
B
C
A
B
C
Control Panel
Cable