Page
1
Air Techniques, Inc.
Contents
Important information
1 Documentation ................................................ 2
1.1 Warnings and symbols ...................................... 2
1.2 Notes on copyright ......................................... 2
2 Safety ........................................................ 3
2.1 Correct use .............................................. 3
2.2 Incorrect use ............................................. 3
2.3 General safety notes........................................ 3
2.4 Radiation protection ........................................ 3
2.5 Qualified personnel ......................................... 3
2.6 Protection against electrical current .................................3
2.7 Only use original parts ...................................... 3
2.8 Transport ................................................ 4
2.9 Disposal ................................................. 4
2.10 Model identification plate ..................................... 4
Product description
3 Overview...................................................... 5
3.1 Technical data ............................................ 6
3.2 Dimensions .............................................. 7
Equipment Setup
4 Pre-Installation Requirements . . . . . . . . . . . . . . . . . . . . . . . . . 8
4.1 Delivery contents ...........................................8
4.2 Special accessories .........................................8
4.3 Required tools not supplied ...................................8
4.4 FDA reporting form .........................................8
4.5 Installation mounting hardware .................................9
4.6 Site preparation . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10
4.7 Support load requirements. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11
4.8 Electrical power requirements ................................ 11
4.9 Wiring length and gauge requirements ............................ 11
4.10 Remote switch configurations ................................ 12
5 Installation .................................................... 14
5.1 Installation procedure summary ............................... 14
5.2 Control unit disassembly for base unit access .................... 15
5.3 Base unit lock side setup ................................... 16
5.4 Base unit wall mounting options .............................. 17
5.5 Installing the horizontal arm .................................. 18
5.6 Installing the scissor arm .................................... 19
5.7 Mounting the X-ray emitter .................................. 20
5.8 Connecting the mains power ................................. 21
5.9 Connecting the handheld exposure button ...................... 21
5.10 Assembling the control unit .................................. 22
5.11 Scissor arm tension alignment ................................ 25
5.12 Connecting the door switch (Interlock) .......................... 26
Equipment Commissioning
6 Operation .................................................... 26
6.1 Acceptance test .......................................... 26
6.2 Electrical safety check ...................................... 26
6.3 Switch unit on ............................................ 26
6.4 Generator Warm-Up ....................................... 26
6.5 Service menu settings via the control panel ....................... 27
Warranty ....................................................... 28
To Next Page
Loading...
