26
• Now raise the vehicle’s arms again until the value for HI
PROX on the display changes from 0 to a 3- or 4-digit
number. Immediately stop the arms.
• Measure the height from the ground to the arms as before.
This height should be around 100 inches, but see the
BinMaxx Installation Guide for an exact height.
• If the distance is much lower or higher than this, adjust
your target until it engages at the correct height. Make sure
you tighten your targets completely after adjusting them.
3. If lift data is still not being recorded, call Air-Weigh Support
for further assistance.
Troubleshooting | Lift Data Was Not Recorded
To Next Page
Loading...
