Air Weigh BinMaxx - Entering Empty and Heavy Weights

4
Entering Empty and Heavy Weights
1. Select two bins that are the same size and the same weight
within 20 to 40 pounds of each other. Alternatively, you can
use one bin and empty it after the heavy weight calibration,
but this may be more time consuming.
2. Weigh one of the bins on the ground scale while it is empty.
3. Enter the empty weight of the bin, with no contents, into your
BinMaxx scale. This weight will be subtracted from the weight
the scale measures to give you the content weight of the bin.
• Turn the vehicle on. Press ESC to access the main menu.
• Press▼untilSETUPisashing.PressOK.
• Press▼untilCALWTSETUPisashing.PressOK.
• Press▼untilEMPTYWEIGHTisashing.PressOK.
• Use▲or▼toentertheemptyweightrecordedabove.
Press OK. The screen will read ACCEPTED.
4. Remove the empty bin from the ground scale.
5. Add the weight of the empty bin to the average weight of your
bin contents (see Determining Bin Weights for Calibration).
Add100poundstothistotaltondtheheavyweight.
6. Enter the heavy weight into your BinMaxx scale.
• Press ESC to return to the CAL WT SETUP screen.
• Press▼untilHEAVYWEIGHTisashing.PressOK.
• Use▲or▼toentertheheavyweight.PressOK.The
screen will read ACCEPTED.
7. Remove the heavy bin from the ground scale.
8. Place the empty and heavy bins near the vehicle.
Calibrating Your Scale | Entering Empty, Heavy Weights