Air Weigh BinMaxx - Turning the Default Reset Lifts Prompt Off or On; Assigning a Truck Number

17
Turning the Default Reset Lifts Prompt Off or On
Under the menu heading Power-Up Mode, you can decide whether
the scale asks you to reset the lift number and net weight each time
it is turned on, or whether you need to go into the erase menu to do
so. If you reset your lift information daily, using power-up mode may
save you time.
1. From the weight display, press ESC to reach the main menu.
2. Press▼untilSETUPisashing.PressOK.
3. Press▼untilPWRUPMODEisashing.PressOK.
4. The screen will show PROMPT RESET (select to show reset
prompts each time you turn on the scale) or DON’T PROMPT
(selecttohideprompts).Use▲or▼toselectanoption.
Press OK to save changes.
Assigning a Truck Number
If you have multiple vehicles, you may use truck numbers
to organize weight information. Truck number will display on
documents printed with the date/time printer and in data streams to
the onboard computer, as well as on spreadsheets generated with
BinMaxx XL.
1. From the weight display, press ESC to reach the main menu.
2. Press▼untilSETUPisashing.PressOK.
3. Press▼untilTRUCKNUMBERisashing.Itisnot
immediately visible on the setup menu. Press OK.
4. The screen will display TRUCK NUMBER and below this,
aashingnumber.Use▲or▼arrowstoselectanumber
between 0 and 9999. Press OK to accept the selection.
Using BinMaxx | Setting Up Your Scale