Air Weigh BinMaxx - Lift Data Was Not Recorded

25
Lift Data Was Not Recorded
BinMaxx may not record lift data if the targets are incorrectly
placed, if the bin is too light, or if the lift operator does not follow lift
procedure necessary for BinMaxx to operate.
1. If a lift is not recorded, an error message should show on
themainscreenofyourBinMaxxdisplay.Seep.28tond
the reason for the error. In most cases, lift data will not be
recorded because of either an operator error or because the
bin content weight was less than 40 pounds. If the error code
is an operator error, consult p. 9 for instructions on lifting
smoothly to allow lift data to be recorded.
2. If no error message displays, your targets may be incorrectly
placed. Test your vehicle for inaccurate placement.
• Make sure your vehicle’s arms are completely down.
• From the weight display, press ESC to reach the main
menu.
• Press▼untilDIAGNOSTICSisashing.PressOK.
• Press▼untilECUisashing.PressOK.
• Press▼untilSENSORDATAisashing.PressOK.
• Press▼once.YoushouldseePROXSWITCH.
• Lift your scale arms until the value for LO PROX changes
from 0 to a 3- or 4-digit number. Immediately stop the
arms.
• Measure the height from the ground to the arms. This
height should usually be around 50 inches, but see your
BinMaxx Installation Guide for an exact height for your
model.
• If the distance is much lower or higher than this, adjust
your target until it engages at the correct height.
Troubleshooting | Lift Data Was Not Recorded