Air Weigh BinMaxx - Page 32

29
EMPTY BIN LIFTED &
EMPTIED
Net weight was less than
40 lbs, gross bin weight
was less than 1000
pounds.
BinMaxx does not record
content weights less than
40 pounds.
BIN CONTENTS NOT
EMPTIED
Net weight was less than
40 lbs, gross bin weight
exceeded 1000 pounds.
Recorded as zero net
weight.
BinMaxx does not record
content weights less than
40 pounds. This error is
caused when the scale
thinks the weight of the
bin itself is so great that
the contents must not
have been emptied.
Check to see if the
contents were emptied.
LIFT STALL BETWEEN
SWITCHES
Gross weight exceeded
100 lbs and lift was hung
between switches for
over ten seconds. No lift
data will be recorded.
The operator took
too much time in the
measurement zone
during the lift.
LIFT SKIPPED LOW
SWITCH
BinMaxx was turned on
when forks were already
in the lift zone, then
were lifted above the lift
zone. No lift data will be
recorded.
The ComLink was
powered on when the
forks were already in the
lift zone.
BAD LEFT DEFLECTION
SENSOR
Leftdeectionsensor
is not reading correct
weights.
Bad or damaged
deectionsensor;
broken or disconnected
deectionsensorcable.
BAD RIGHT
DEFLECTION SENSOR
Rightdeectionsensor
is not reading correct
weights.
Bad or damaged
deectionsensor;
broken or disconnected
deectionsensorcable.
NO PRINTER
COMMUNICATION
No date/time acquired
from printer for ten
seconds. (ComLink tries
to acquire date/tire every
0.5 seconds.)
Printer not connected;
need to set date/time.
NO NET DATA
RECORDED
Error displayed when
printed or via BinMaxx XL
spreadsheet - BinMaxx
did not record any data.
Forks too high when in
travel mode; adjust prox
target or lower travel
mode height.
Troubleshooting | Identifying Error Messages