HELO H.264 Streaming and Recording Encoder v1.1r1 5 www.aja.com
Chapter 1 – Introduction
Overview
HELO is AJA’s first hardware-based H.264 solution. HELO can receive video
output from a switcher, camera or other device and deliver the stream directly
to a Content Delivery Network (CDN) via RTMP or RTP/UDP-TS. HELO can also
simultaneously record the video to its built-in SD slot, to a USB flash drive
attached to its USB 2.0 port, or to a local shared network drive via its Ethernet
port. This lets you configure your recording and streaming independently for
maximum efficiency and flexibility.
HELO has both HDMI and SDI video interfaces for inputting either type of signal,
as well as analog stereo audio in and out. Two hardware buttons are conveniently
located on the front, one for stream and one for record.
HELO is configured by default for DHCP network communications, so installation
can be as easy as just plugging in the Ethernet cable. A USB connection with AJA’s
eMini-Setup application also allows quick access directly to the HELO hardware
for network configuration, if necessary.
HELO uses a web browser based UI, where all of HELO’s controls are ready
to use. The robust web browser UI allows you to setup and configure your
CDN connection before you even arrive at your event. Once there, even an
inexperienced operator can start and stop streaming and recording with simple
button pushes. The web UI also provides complete control of HELO’s operations
from a remote location.
To Next Page
Loading...
