AJA HELO - Wowza; Using the Local Wowza Streaming Engine

HELO H.264 Streaming and Recording Encoder v1.1r1 52 www.aja.com
Wirecast Configuration Summary
1. Add web stream
2. Change protocol to RTSP
3. Stream options: RTSP over UDP
4. Format Options: Auto Detect
5. Check Live Stream
6. Enter URI of the HELO
7. Click OK, NOT connect
8. In congure tab click connect
Additional information is available at https://www.telestream.net/wirecast/
overview.htm
Wowza
Wowza Media Systems offers a Streaming Server that can be run on either a local
or cloud based server. For general information about Wowza Media Systems, see:
https://www.wowza.com/
Using the Local Wowza Streaming Engine
NOTE: This section assumes that you have already installed and configured the local
Wowza Streaming Engine media server. For instructions on installation and
configuration, see the following:
https://www.wowza.com/docs/how-to-install-and-configure-wowza-streaming-
engine
Gather Wowza Application Connection Settings
Once you have installed and configured your local Wowza Streaming Engine
media server, follow these steps to gather your Wowza Application Connection
Settings, then enter them into your HELO's Streaming Profile Configuration.
1. Launch a web browser, then navigate to your local server installation of the
Wowza Streaming Engine Manager.
2. In the left column, under the "Selected Application" heading, select the
application you want to use.
3. From the selected application sub-menu, select "Sources (Live)". The
Sources (Live) page displays.
4. From the far right column of the Sources (Live) page, under the heading
"Application Connection Settings," note the following:
• Host Server IP Address
• Host Port Number
• Application Name
Enter Settings into HELO Streaming Profile Configuration
1. From your HELO web user interface, select the Streaming Proles menu. The
Streaming Prole Settings page displays.
2. In the Stream Type eld, select RTMP.