1
83
Ki Pro Installation and Operation Manual — Web Browser via Ethernet
Clip Number (17.3): This parameter determines the clip number, from 1 to 999, that
follows the CLIP NAME, and is associated with all clips generated while using this
setting. To enter a specific value, click on the number to highlight it, type in a value,
and press Enter to confirm the value. You may also click and drag on the slider to
make adjustments. To increment by single values using the slider, click the slider to
highlight it, and press the "back" arrow or "forward" arrow on your keyboard.
Clip Append (17.4): This parameter is used with parameter 17.5 ALPHA APPEND to
append a text value after the CLIP NUMBER or have no text appended.
Alpha Append (17.5): This parameter is used with parameter 17.4 CLIP APPEND to
append a text value after the CLIP NUMBER.
Take (17.8): This parameter determines the TAKE number, from 1 to 999, that follows
the CLIP NAME and CLIP NUMBER, followed by any ALPHA APPEND (if selected),
generated for all clips while using this setting. To enter a specific value, click on the
number to highlight it, type in a value, and press Enter to confirm the new value.
You may also click and drag on the slider to make adjustments. To increment by
single values using the slider, click the slider to highlight it, and then press the
"back" arrow or "forward" arrow on your keyboard.
Use Custom Clip Name (19.1): This parameter enables or disables whether a custom clip
name can be used. Refer to “Custom Clip Naming” in Chapter 3 for greater detail.
Custom Clip Name (19.2): This parameter allows you to enter a custom clip name. To
enter, click on the default name, “Custom” and type a new name. Once entered,
you’ll have to click the Apply button for it to take effect and be used.
Use Custom Clip Take (19.3): This parameter enables or disables whether a custom clip
take name can be used. Refer to “Custom Clip Naming” in Chapter 3 for details.
Caution!
If a custom clip name is not changed and the "Custom Clip Take"
parameter is not enabled, an existing clip can be overwritten on the
disk. Example: the first recording made is called "Flying" and the
"Custom Clip Take" parameter is not enabled; additionally, the user
does not enter a new value for the custom clip name and leaves
"Flying" entered. As a result, the first recording will be overwritten by
the second recording. AJA does not typically recommend disabling
the use of the custom clip take, but in some situations, overwriting an
existing file may be desirable.
Note: the selection of the Custom Clip Take is only possible via the web UI and it
does not survive reboots.
Custom Take (19.4): This parameter allows you to define a custom take number. Once
entered, you’ll have to click the Apply button for it to take effect. To enter a specific
value, click on the number to highlight it, type in a value, and press Enter to confirm
the new value. You may also click and drag on the slider to make adjustments. To
increment by single values using the slider, click the slider to highlight it, and then
press the "back" arrow or "forward" arrow on your keyboard.
Gang Clip Name (22.1): This parameter is used when performing gang recording via
multiple Ki Pros (refer to Controlling Multiple Ki Pros earlier in this Chapter). If you
want to name clips the same way across all the recordings of Ki Pro ganged units,
then use the "Master Name" pull down selection. If you want to name clips
independently on Ki Pro units, then select "Slave Name" from the pull down.
Selecting "Slave Name" means that the recording will take its name from the
individual Ki Pro's parameters and not accept the value pushed to the Slave by the
Master Ki Pro. Refer to “Custom Clip Naming” in Chapter 3 for greater detail.
To Next Page
Loading...
