AJA Ki Pro - Chapter 4: Browser Remote Control; Remote Control Overview; Web Browser via Ethernet

1
57
Ki Pro Installation and Operation Manual — CONFIG menus
1.5 OUT CONVERT
This parameter defines the type of up, down, cross, or aspect-ratio conversion, if any,
applied to the output when playing media from storage or while recording.
Note: There is one converter available for output—if selected, it will be applied as appropriate,
based on other settings (1.6, 1.7 and 1.8) possibly affecting multiple outputs.
Output conversion of 1080psf23.98 is only supported for SD (not 720p).
1.6 SDI OUT
This parameter defines whether the SDI output matches the file format or has the 1.5
OUT CONVERT selection applied to it.
Note: The “FILE FRMT” (file format) is from the file on playback and is the result of any input
conversion (or none) applied during capture.
1.7 COMPONENT OUT
This parameter defines whether the component video output matches the file format
or has the 1.5 OUT CONVERT selection applied to it.
Note: Setting the Ki Pro component input and/or output to "Beta" for HD material will result in
an "Invalid Selection" alarm that will need correction before recordings or other operations
may take place.
1.8 HDMI OUT
This parameter defines whether the HDMI output matches the file format or has the 1.5
OUT CONVERT selection applied to it.
1.9 SUPER OUT
This parameter provides superimposition of timecode and transport state (Record,
Pause, etc.) onto the SDI output.
1.5 OUT CONVERT NONE (default)
SD
HD 720
HD 1080
No conversion on output.
Convert on output to SD
Convert on output to HD 720
Convert on output to HD 1080.
1.6 SDI OUT FILE FRMT (default)
OUT CONVERT
Output with the same format as the file
Output using the selection in 1.5 OUT CONVERT
1.7 COMPONENT OUT FILE FRMT (default)
OUT CONVERT
Output with the same format as the file
Output using the selection in 1.5 OUT CONVERT
1.8 HDMI OUT FILE FRMT (default)
OUT CONVERT FRMT
Output with the same format as the file
Output using the selection in 1.5 OUT CONVERT
1.9 SUPER OUT Off (default)
SDI
Superimposition is disabled
Superimposition is enabled for the SDI output