74
55.6 TIME SET
This parameter manually sets the time of the internal Ki Pro clock, when setting
manually (NTP not used).
70.1 SCREEN SAVER
When set to “AJA Logo”, a rolling AJA logo screen saver will appear on the
alphanumeric display after 3 minutes of inactivity—defined as no button presses on
the front panel. When the Screen saver is on, the STATUS button or STOP button will
exit the screen saver.
Note: The screen saver will not appear if an active transport function is underway (e.g., Play,
Record, etc.).
70.2 DISPLAY INTENSITY
This parameter determines the brightness of the alphanumeric VFD display and front
panel backlit buttons. A dimmer display uses less power.
55.6 TIME SET variable Using the adjust buttons, enter a time for Ki Pro’s clock.
Using the adjust buttons and the top Select button, select
the characters for each digit (hours/minutes). The adjust
buttons scroll through the choices and the top Select
button advances to the next character. While selecting
characters, the character being changed will flash to
show its position. When finished, the final press of the
SELECT up button will flash the whole value, hit SELECT
once more to confirm and the next menu parameter will
appear. Time is set using a 24 hour format (military) and
must be set to GMT time.
Note: there are many websites that will assist you in
converting your local regional time to GMT (UTC). AJA
does not endorse any particular one, but here are two
examples:
http://tycho.usno.navy.mil/zones.html
http://hurricanes.noaa.gov/zulu-utc.html
70.1 SCREEN SAVER ON (AJA LOGO) (default)
OFF
SYSTEM NAM
Display horizontally rolling AJA logo after 3 minutes of
button inactivity
Screen saver is disabled.
Display the Ki Pro system name set in parameter 50.5.
70.2 DISPLAY INTENSITY variable Using the adjust buttons, you can dim or brighten the
alphanumeric display and activity indicator LEDs in steps
from 1 (dim) to 8 (brightest)
Default: 6
To Next Page
Loading...
