54
Custom clip names can be created via the front panel UI menu parameters (19.1, 19.2,
and 19.4) through the use of the Select and Adjust arrows. Users may find that the
more efficient method to perform custom clip naming is via the web UI entry fields.
Note: when entering characters for a custom clip name, you must scroll through all
characters using the Adjust buttons until you reach the end of the name space before
the name is accepted.
19.1 USE CUSTOM CLIP NAME
This parameter enables or disables whether a custom clip name can be used via
menu parameters 19.1, 19.2, and 19.4, or via the web UI.
19.2 CUSTOM CLIP NAME
This parameter defines a custom clip name. The custom clip name is defined via the
front panel select and adjust up/down arrows. The default name is “CUSTOM”.
19.4 CUSTOM TAKE
This parameter defines a custom take. The custom take number is defined via the
front panel select and adjust up/down arrows.
22.1 GANG CLIP NAME
This parameter is used when performing gang recording via multiple Ki Pros (refer to
Controlling Multiple Ki Pros later in this manual). If the desire is to have clips named
the same across all Ki Pro ganged units' recordings, then use the "Master Name"
selection in this parameter. If the desire is to have clips named independently on Ki
Pro units, then "Slave Name" should be selected. Selecting "Slave Name" means that
the recording will take its name from the individual Ki Pro's parameters and not
accept the value pushed to the Slave by the Master Ki Pro.
19.1 USE CUSTOM CLIP NAME OFF (default)
ON
Enable defining of custom clip name
Disable defining of custom clip name
19.2 CUSTOM CLIP NAMEE variable Using the adjust buttons, enter a custom clip name.
Using the adjust buttons and the top Select button, select
the characters for the name. The adjust buttons scroll
through the choices and the top Select button advances
to the next character. While selecting characters, the
character being changed will flash to show its position.
Certain characters may not be allowed or supported if
entered for a clip name. Examples include: punctuation
marks (other than internal spaces or periods), special
characters (like @), and non-ASCII UTF-8 characters are
rejected outright. Note: non-UTF-8 characters appear in
some languages, like Chinese and Japanese, and are not
supported.
Default: CUSTOM
19.4 CUSTOM TAKEE 1 to 999
(default = 1)
Press ADJUST button up or down to change the
TAKE value from 1 to 999, if a value other than the
automatically generated value is desired.
22.1 GANG CLIP NAME Master Name (default)
Slave Name
Name clips the same across all Ki Pro ganged units
Name clips independently on Ki Pro units
To Next Page
Loading...
