Akai CD-55 - Page 9

Operation
Point the remote control unit at the REMOTE SENSOR win-
dow, and press the desired operation button.
If the remote control unit will only operate from a short distance
or narrow angle, this indicates that the battery voltage is low.
Replace all the batteries with new ones.
When replacing the batteries, clean all the remote control and
battery terminals with a dry cloth.
Ot 08OKO" 0-0-0
| Of
How to load the batteries
Slide the battery compartment cover in the direction of the
arrow, and remove it.
Load the batteries according to the polarity guides on the
remote control unit.
3 Replace the battery compartment cover.
Cautionary notes
On the remote control unit
@ Avoid dropping the remote control unit or getting it wet.
@ Avoid exposing the remote control unit to direct sunlight or
strong light as this may cause malfunction.
@ Do not use re-chargeable batteries.
nh the dry batteries
@ Insert the batteries matching their polarity guides with the
markings in the remote control battery compartment.
@ When you do not plan to use the remote control unit fora
long period of time, remove the batteries.
@ Read the cautions printed on the batteries before inserting
them.
@ When replacing the batteries, replace them ail at the same
time. Do not mix old batteries with new ones.