EasyManuals Logo

ALC SightHD SensorCam User Manual

ALC SightHD SensorCam
59 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #10 background imageLoading...
Page #10 background image
— 8 —
INSTALLATION
Installing the Camera
u
If not mounting, but just using on a flat
surface (desk, table, etc.), skip to step 3
v
Insert the two screws (and anchors, if
needed) into a stable surface, ceiling or
wall 5.5cm apart and level.
w
Loosen the T-Bolt on the Camera Bracket
using a screwdriver, coin or similar tool
and adjust viewing angle. When set to the
desired position, rotate clockwise until
tight.
If hanging on a wall, ceiling, etc., slide the
Camera Bracket onto the screws.
x
The 8GB SD card comes pre-installed.
To insert a different card, remove the
compartment cover by sliding it off. Push
the SD cover forward to unlock it, then
flip it open. Insert the new SD card and
reverse procedure to close.
NOTE:
Supports up to a 32GB microSD card.
Back of
the card
1
2

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the ALC SightHD SensorCam and is the answer not in the manual?

ALC SightHD SensorCam Specifications

General IconGeneral
BrandALC
ModelSightHD SensorCam
CategorySecurity Camera
LanguageEnglish

Related product manuals