Managing Power over Ethernet (PoE) Power over Ethernet Specifications
OmniSwitch 6250 Hardware Users Guide September 2015 page 6-3
Power over Ethernet Specifications
The table below lists general specifications for Alcatel-Lucent’s Power over Ethernet support. For more
detailed power supply and Power Source Equipment (PSE) specifications, refer to Chapter 3,
“OmniSwitch 6250 Chassis and Hardware Components.”
Note. Ports pairs 23/24 and 25/26 cannot have PoE enabled at the same time. By default, ports 23/24 have
PoE capability enabled and ports 25/26 have PoE capability disabled. See “Enabling/Disabling PoE on
Copper Combo Ports” on page 6-6 for information on enabling PoE on the copper combo ports.
IEEE Standards supported
IEEE 802.3af; 802.3at
Default PoE administrative status Enabled
Default PoE operational status Disabled (PoE must be activated on a switch-
by-switch basis via the lanpower start
command.)
Platforms supporting PoE OmniSwitch 6250-P24
Cable distances supported 100 meters (approx.)
Total number of PoE-capable ports per switch 24
Default amount of inline power available (1-6, 23/24
or 25/26)
Default amount of inline power available (7-22)
31000 milliwatts
16000 milliwatts
Range of inline power allowed (1-6, 23-24 or 25-26)
Range of inline power allowed (7-22)
3000 - 31000 milliwatts
3000 - 16000 milliwatts
PoE Power Supply 225 Watts
To Next Page
Loading...
