Alcatel-Lucent OmniSwitch 6250 - LED Status

OmniSwitch 6250-P24 OmniSwitch 6250 Chassis and Hardware Components
page 3-20 OmniSwitch 6250 Hardware Users Guide September 2015
LED Status
LED State Description
OK Solid Green
Blinking Green
Solid Amber
Normal Operation.
Boot up/Remote Config Load in
Progress
Operating Temperature Exceeded.
PRI Solid Green
Solid Amber
Off
Primary unit in a stack or standalone
switch.
Secondary unit in a stack.
Switch is idle. (not primary or
secondary)
PWR Solid Green
Amber
Off
P/S Normal Operation.
P/S Present and Bad (24-port models
only)
P/S Not Present or Bad.
BPS Solid Green
Amber
Off
P/S Normal Operation.
P/S Present and Bad (24-port models
only)
P/S Not Present or Bad.
STK Green
Amber
Unit in Stacking Mode
Unit in Standalone Mode
Stack A/ Stack B Green
Amber
Off
Valid Uplink
Valid Stacking Link
No Link Detected.
10/100/1000 Ports Solid Green
Blinking Green
Solid Amber
Blinking Amber
Off
Valid Link
Transmitting or receiving packets in
a link up state for non-PoE .
Valid PoE Link.
Transmitting or receiving packets in
a link up state for PoE .
No Link Detected.
SFP Ports Solid Green
Blinking Green
Off
Valid Link.
Transmitting or receiving packets in
a link up state .
No Link Detected.
Push Button Operation When pushed all LEDs will turn off
and the LED of the Stack ID will
remain lit.