Mounting OS6250 Switches Mounting OS6250 Switches
page 4-24 OmniSwitch 6250 Hardware Users Guide September 2015
OS6250-WALL-MNT - Wall-Mounting Installation
1 Follow the proper assembly instructions based on the configuration of the chassis and power supply
trays described in “Assembling OS6250 Switches” on page 4-6.
2 Orient the wall-mount brackets so that the rubber bumpers are facing down. Attach the brackets to
both the left and right side of the switch, as shown.
Attaching the wall-mount brackets.
3 Attach two additional mounting brackets to the rear portion of the chassis so that the rubber bumpers
are facing down. Attach the brackets to both the left and right side of the switch.
4 Use one person to securely hold the chassis assembly in position on the wall. Mark the location of the
holes in the mounting brackets on the wall.
5 Pre-drill the wall (if required).
Recommended Wall Mount Chassis Orientation (OS6250-WALL-MNT)
NOTE: For wall mounting, it is recommended that the
chassis assembly is oriented sideways, with the chassis
front panel facing left, as shown in the diagram below.
Wall surface
Chassis
To Next Page
Loading...
