Alcatel-Lucent OmniSwitch 6250 User Manual

Getting Started Booting the Switch
OmniSwitch 6250 Hardware Users Guide September 2015 page 2-5
Booting the Switch
Now that you have installed the switch components and connected network and management cables, you can
boot the switch. To boot the switch, plug the power supply cord into an easily-accessible, properly grounded
power outlet. (Do not use extension cords.) The switch will power on and boot automatically.
Component LEDs
During the boot process, component LEDs will flash and change color, indicating different stages of the boot.
Following a successful boot, chassis LEDs should display as follows:
Note. If the LEDs do not display as indicated, make sure the boot process is complete. If the LEDs do not
display as indicated following a complete boot sequence, contact Alcatel-Lucent Customer Support. For
information on LED states, refer to “Chassis Status LEDs” on page 3-19.
Once the switch has completely booted and you have accessed your computer’s terminal emulation software
via the console port, you are ready to log in to the switch’s Command Line Interface (CLI) and configure basic
information. Continue to “Your First Login Session” on page 2-6.
OK1 Solid Green
PRI Solid Green
PWR Solid Green

Alcatel-Lucent OmniSwitch 6250 Specifications

General

Model	OmniSwitch 6250
Port Configuration	Fixed
Uplink Ports	4 x 10G SFP+
Operating System	AOS (Alcatel-Lucent Operating System)
Jumbo Frame Support	Yes
Product Type	Switch
Ports	48
Power over Ethernet (PoE)	Yes
Form Factor	Rack-mountable
Management	CLI, Web, SNMP
MAC Address Table Size	16, 000
Routing Protocol	OSPF, RIP, BGP
Power	AC
Power Supply	Dual redundant
Operating Temperature	0°C to 45°C
Operating Humidity	10% to 90% (non-condensing)